MUTOH Kona 760 Service Manual page 63

Remove Y-rail as follows:
Step 5:






AP-74380 - Revision 1.1
Support the Y-rail so it can not fall when disassembling it.
Loosen the grounding strip avoiding static electricity on top of the Y-rail.
Remove the 4 screws fixing the Y-rail at both sides.
Insert the drive belt in the Y-rail.
Tilt out the Y-rail and be careful not to damage the flatcables.
Support the Y-rail when laying it down on a table.
Service manual Kona cutting plotter
Part replacement
3
63