MUTOH Kona 760 Service Manual page 136

Service manual Kona cutting plotter
Troubleshooting
Error Message
Thickness problem
6251
frame centre
Thickness problem
6252
frame centre
Thickness problem
6253
frame centre
Thickness problem
6254
frame centre
Thickness problem
6255
frame centre
Thickness problem
6256
frame centre
136
Description
Thickness of centre points (P9 & P10) differs too much from
each other AND differs also from bottom points P1 and P4.
Invalid thickness of P9 (right centre point). Thickness varies
too much from P10! This will influence the accuracy of the
cutting.
Invalid thickness of P10 (left centre point). Thickness varies
too much from P9! This will influence the accuracy of the
cutting.
Thickness of centre points (P11 & P12) differs too much
from each other AND differs also from bottom points P1 and
P4.
Invalid thickness of P11 (right centre point). Thickness
varies too much from P12! This will influence the accuracy
of the cutting.
Invalid thickness of P12(left centre point). Thickness varies
too much from P11! This will influence the accuracy of the
cutting.
Solution
You can try to cut the job if you want
to. Perfect quality is not
guaranteed. What to check in case
of bad quality:
Printer settings

RIP settings

Design

AP-74380 - Revision 1.1
Category
Warning