3.6.3
Pressure roller assembly
Tools necessary
P1 and P2 screwdriver
Hexagon wrench 5,5 mm
Hexagon key 2,5 mm
Replacement procedure
Follow the procedure below to replace the pressure roller assembly.
Remove all the covers of the cutter
Step 1:
Refer to
Remove the following parts first:
Step 2:
Part
Penhead
Penhead drive belt
Y-motor
Speed reduction belt and pulley
Touchscreen
Loosen all flatcable brackets at the right side and unplug the flatcables.
Step 3:
Note
Try not to bend the flatcables too much. Frequently folding the cables will
damage them.
AP-74380 - Revision 1.1
Cover removal on page 27
Service manual Kona cutting plotter
Procedure
Penhead assembly on page 44
Penhead drive belt on page 47
Y-motor on page 36
Y-drive pulley and speed reduction belt on page 38
Touchscreen on page 80
Part replacement
3
61