Penhead Drive Belt Tension - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Adjustments and calibrations
4.1.3

Penhead drive belt tension

After replacing the following parts:
Y-drive pulley and speed reduction belt
Y return pulley replacement
Penhead drive belt replacement
Pressure roller assembly replacement
Adjustment procedure
Follow the procedure below to adjust the tension of the penhead drive belt.
Step 1:
Step 2:
88
Part
Move the penhead from the far left to the far right of the machine. The penhead
drive belt position on the Y-return pulley should remain the same. If it is moving up
and down, adjust the two screws fixing the Y-return pulley.
Park the penhead at the left side of the machine.
Y-drive pulley and speed reduction belt on page 38
Y-return pulley on page 39
Penhead drive belt on page 47
Pressure roller assembly on page 61
Link
AP-74380 - Revision 1.1