Introduction; How To Start Up In Diagnostics Mode 1 And 2; Diagnostics 1 - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Diagnostics mode
5.1

Introduction

Diagnostics is a powerful tool in the firmware made for the authorized Mutoh technician to
control/check a lot of settings, features, parts...
Diagnostics can be used as well when the machine starts-up correctly (diagnostics 1), but
also when the cutting plotter does not pass the initialization procedure (diagnostics 2).
Please read this chapter thoroughly to know how to enter both these diagnostics modes and
how to perform several tests.
5.2

How to start up in diagnostics mode 1 and 2

5.2.1

Diagnostics 1

Step 1:
Step 2:
Step 3:
Step 4:
106
Power on the machine at the side.
Wait until the Kona has been initialized.
Press the following buttons in order:
Settings

1 x previous page

m
Diagnostics

Press enter when the following screen appears to access diagnostics mode 1
AP-74380 - Revision 1.1