MUTOH Kona 760 Service Manual page 65

Reassembling notes
Be sure to push the Y-rail to the front against the positioning points on the side frames before
fixing the rail.
Be sure to guide and tighten the flatcables in the same way as shown on the picture below:
Adjustments necessary
After replacing this part, it is necessary to make the following adjustment.
N°
EPOS calibration
1
Penhead drive belt tension
2
Y drive belt tension
3
Pressure roller pressure
4
AP-74380 - Revision 1.1
Description
EPOS calibration on page 103
Mechanical adjustments on page 88
Mechanical adjustments on page 87
Mechanical adjustments on page 90
Service manual Kona cutting plotter
Part replacement
Link
3
65