Yz Profile - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Diagnostics mode
5.3.6

YZ profile

Measure up the penhead height all across the width of the cutter. After the test, the cutter will
automatically save the parameters on condition that the values do not fluctuate too much.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
114
Install a knife that is completely screwed in!
Be sure that the cutting mat is still in good shape and not worn out. Otherwise the
measurement will be incorrect.
Unload media and be sure that the lever is up.
Move the pressure rollers to the following position:
Kona 760 - on grit roller 1 and 6

Kona 1400 - on grit roller 1 and 5 and 11

Kona 1650 - on grit roller 1 and 6 and 13

Pull the lever down.
Go to diagnostics mode 1.
Refer to Diagnostics 1 on page 106
Press on the YZ profile button to start the measurement.
The penhead will go down and move over the cutting mat from right to left.
After the measurement, there are two possible conclusions:

YZ Profile DONE

Measurement is completed successfully and the parameters have been saved.
YZ Profile disapproved

The measured values fluctuate too much. The default parameters are loaded
again. Please contact our Service Department (service@mutoh.eu) for support.

AP-74380 - Revision 1.1