MUTOH Kona 760 Service Manual page 134

Service manual Kona cutting plotter
Troubleshooting
Error Message
Thickness problem
6231
frame bottom
Thickness problem
6232
frame bottom
Thickness problem
6233
frame bottom
Thickness problem
6234
frame bottom
Thickness problem
6235
frame bottom
Thickness problem
6236
frame bottom
Thickness problem
6237
frame bottom
134
Description
All measured points of frame bottom vary too much from
each other! This will influence the accuracy of the cutting.
Invalid thickness of P1 (right side of frame bottom).
Thickness varies too much from other bottom points! This
will influence the accuracy of the cutting.
Invalid thickness of P2 (bottom right of frame bottom).
Thickness varies too much from other bottom points! This
will influence the accuracy of the cutting.
Invalid thickness of P3 (bottom left side of frame bottom).
Thickness varies too much from other bottom points! This
will influence the accuracy of the cutting.
Invalid thickness of P4 (left side of bottom point). Thickness
varies too much from other bottom points! This will
influence the accuracy of the cutting.
Invalid thickness of P1 and P4. Thickness of these points
varies too much from each other AND varies also from P2 &
P3! This will influence the accuracy of the cutting.
Invalid thickness of P2 and P3. Thickness of these points
varies too much from each other AND varies also from P1 &
P4! This will influence the accuracy of the cutting.
Solution
You can try to cut the job if you want
to. Perfect quality is not
guaranteed. What to check in case
of bad quality:
Printer settings

RIP settings

Design

AP-74380 - Revision 1.1
Category
Warning