MUTOH Kona 760 Service Manual page 95

The machine will restart automatically.
Step 12:
Note
It might be possible that the machine does not restart because of an update

failure or a power down during the update sequence. The 4 error LEDs on the
mainboard will start blinking. Solve this issue by sending the firmware file once
again.
Verify that the firmware and drivers has been updated correctly. The firmware
Step 13:
version will be displayed in the upper left corner of the mainscreen.
f
AP-74380 - Revision 1.1
Service manual Kona cutting plotter
Adjustments and calibrations
4
95