MUTOH Kona 760 Service Manual page 135

Service manual Kona cutting plotter
Troubleshooting
Error Message
Thickness problem
6241
frame top
Thickness problem
6242
frame top
Thickness problem
6243
frame top
Thickness problem
6244
frame top
Thickness problem
6245
frame top
Thickness problem
6246
frame top
Thickness problem
6247
frame top
135
Description
All measured points of frame top vary too much from each
other! This will influence the accuracy of the cutting.
Invalid thickness of P5 (right side of frame top). Thickness
varies too much from other top points! This will influence the
accuracy of the cutting.
Invalid thickness of P6 (top right of frame top). Thickness
varies too much from other top points! This will influence the
accuracy of the cutting.
Invalid thickness of P7 (top left side of frame top).
Thickness varies too much from other top points! This will
influence the accuracy of the cutting.
Invalid thickness of P8 (left side of top point). Thickness
varies too much from other top points! This will influence the
accuracy of the cutting.
Invalid thickness of P5 and P8. Thickness of these points
varies too much from each other AND varies also from P6 &
P7! This will influence the accuracy of the cutting.
Invalid thickness of P6 and P7. Thickness of these points
varies too much from each other AND varies also from P5 &
P8! This will influence the accuracy of the cutting.
Solution
You can try to cut the job if you want
to. Perfect quality is not
guaranteed. What to check in case
of bad quality:
Printer settings

RIP settings

Design

AP-74380 - Revision 1.1
Category
Warning