Y-Drive Pulley And Speed Reduction Belt - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Part replacement
3.3.3

Y-drive pulley and speed reduction belt

Tools necessary
P1 and P2 screwdriver

Replacement procedure
Follow the procedure below to replace the Y-drive pulley and speed reduction belt.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Adjustments necessary
After replacing this part, it is necessary to make the following adjustment.
N°
1
2
38
Remove all covers except the front and rear platen
Refer to Cover removal on page 27
Remove the penhead assembly
Refer to Penhead assembly > Penhead assembly on page 44
Loosen penhead drive belt
Refer to Penhead assembly > Penhead drive belt on page 47
Remove the Y-motor
Refer to Y-motor assembly > Y-motor on page 36
Loosen the screw fixing the Y-drive pulley.
Replace the Y-drive pulley and/or speed reduction belt.
Description
Y drive belt tension
Penhead drive belt tension
Mechanical adjustments on page 87
Mechanical adjustments on page 88
Link
AP-74380 - Revision 1.1