Sensors - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Diagnostics mode
5.3.9

Sensors

When you are in doubt of the correct functioning of the sensors, verify it as follows:
Step 1:
Step 2:
Step 3:
Step 4:
116
Go to diagnostics mode 1 or 2.
Refer to Diagnostics 1 on page 106
Refer to Diagnostics 2 on page 107
Press on the Sensors button.
The status of the sensors will be displayed:
Manipulate the sensors as follows:
Media Front Left

Media Front Right

Media Rear

Lever

Pinch Flap

Dip Switches

XY voltage

rd
EPOS (3 value)

Sensor is covered
Sensor is uncovered
Sensor is covered
Sensor is uncovered
Sensor is covered
Sensor is uncovered
Lever is down
Lever is up
Head is in front of a pressure roller
Head in not in front of a pressure roller
Dipswitch on mainboard is ON
Dipswitch on mainboard is OFF
48V The value should be 48V ± 5% (45,6 V - 50,4V)
white The vinyl under the epos sensor is detected as
white
colour The vinyl under the epos sensor is detected as a
coloured one
AP-74380 - Revision 1.1