Service manual Kona cutting plotter
Adjustments and calibrations
Step 8:
Step 9:
Step 10:
104
Automatic alignment
Weed out the square and press OK
The cutter will automatically measure
the bottom and right side of the box, to
know the distance between the EPOS
sensor and the knife tip.
The EPOS calibration has been
finished.
Manual alignment
Weed out the squares and press OK
The EPOS laser will be activated and
will move to the approximate centre of
the cross. Guide the laser to the
perfect centre (if necessary) of the two
squares and confirm the position with
OK.
The EPOS calibration has been
finished.
AP-74380 - Revision 1.1
m