Penhead Assembly - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Part replacement
3.4.3

Penhead assembly

Tools necessary
P2 screwdriver

Hexagon wrench 5,5 mm

Hexagon key 2,5 mm

Replacement procedure
Follow the procedure below to remove the penhead assembly.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
44
Remove the following covers first:
Remove the following covers first
Side covers

Y-rail cover

Penhead cover

Refer to Cover removal on page 27
Disconnect the 3 flex cables.
Loosen the two hexagon spacers.
Move the penhead to the middle of the machine.
AP-74380 - Revision 1.1