Measure with a bar tension gauge (range: 500 g) the tension of the belt in the
Step 3:
middle of the Y-rail. Push the belt with the bar tension until it touches the rail and
release gently the pressure on the gauge. When the belt starts to release from the
rail is the moment of reading the value on the bar tension gauge. The tension
depends of the size of the Kona.
If the value is out of range, turn the two screws of the Y-return pulley an equal
Step 4:
amount to the left or right.
AP-74380 - Revision 1.1
For Kona 760 the value should be 200 g ± 5 g.
For Kona 1400 the value should be 130 g ± 5 g.
For Kona 1650 the value should be 95 g ± 5 g.
Service manual Kona cutting plotter
Adjustments and calibrations
4
89