Service manual Kona cutting plotter
Adjustments and calibrations
Step 3:
Step 4:
Step 5:
92
Adjust the sheet-off knife height so that the metal bracket of the spring-wheel
mechanism does not touch the upper or lower part of the extrusion. Check this over
the complete width of the machine. This way the wheel will control the play of the
front platen.
Adjust the sheet-off knife front and backwards so that the knife is positioned in
between the cutting groove and does not touch the sides.
Tighten the screws when the adjustment has been finished.
AP-74380 - Revision 1.1