Mechanical Adjustments; Drive Belt Tension - MUTOH Kona 760 Service Manual

Service manual Kona cutting plotter
Adjustments and calibrations
4.1

Mechanical adjustments

4.1.1 X drive belt tension
After replacing the following parts:
X motor and drive belt replacement
Grit shaft replacement
Adjustment procedure
Follow the procedure below to adjust the tension of the X drive belt.
Step 1:
Step 2:
Step 3:
86
Part
Loosen the 2 screws fixing the X-motor assembly.
Attach a piece of rope around the motor body, through the hole as close as possible
to the side plate.
Pull the bar tension gauge (range 5kg) in the direction of the slotholes for and
tighten the 2 screws when reaching the value: 3.5 kg ± 0.05 kg.
X-motor and drive belt on page 33
Grit shaft on page 53
Link
AP-74380 - Revision 1.1