MUTOH Kona 760 Service Manual page 130

Service manual Kona cutting plotter
Troubleshooting
Error Message
1060 Sheet off error
2000 PG problem detected
6098 EPOS calibration error
EPOS measurement is
6099
unstable
Bump problem machine
6100
width
X measurement problem.
6105
Reload media
TFT board detection
6115
problem
130
Description
The front sensor is still covered after a sheet-off
Media is too short to perform a PG action
Could not calibrate the pen to laser distance
There is too much variation between the X and
Y calibration measurements
The cutter can not finish the cutter width
measurement routine. This could be caused by
a mechanical obstruction.
The rear media sensor is uncovered during a
media measurement routine
The flatcable of the touch screen is not
connected or broken
Solution
Check if the sheet-off system
Is the cutting blade still sharp?
Load a longer sheet
1. Make sure that the difference between white
and color can be recognized by the EPOS
sensor
2. The media has not been weed out (when
asked on the display) before the EPOS
alignment measurement
3. The laser is broken.
1. Is the media loaded correctly?
Remove the media or object blocking the head
from moving and restart the cutter.
1. Try tIs the media loaded correctly?
1. Check/replace the touchscreen flatcable
Refer to Touchscreen on page 80
2. Check/replace the mainboard
Refer to Mainboard on page 67
Category
Warning
Warning
Warning
Warning
Warning
Warning
Warning
AP-74380 - Revision 1.1