5.3.7
Tool Force
This feature is meant for production purposes only. You will notice that this value will be reset
when restoring the factory defaults. However, this is not an issue since the default settings
are very close to the actual values. We only fine-tune them before shipping the cutters.
5.3.8
Actuators
When you are in doubt of the correct functioning of the
EPOS laser
Fans in paperguide
Buzzer
LED's on the mainboard
verify it as follows:
Go to diagnostics mode 1 or 2.
Step 1:
Refer to
Refer to
Press on the Actuators button.
Step 2:
Select the part you want to test.
Step 3:
Change the value from off to on and verify if the laser, fans, buzzer or LEDs function
Step 4:
correctly.
Press
Step 5:
LEDs.
AP-74380 - Revision 1.1
Diagnostics 1 on page 106
Diagnostics 2 on page 107
to return to the previous menu and deactivate the laser, fans, buzzer or
Service manual Kona cutting plotter
Diagnostics mode
5
115