Service manual Kona cutting plotter
Troubleshooting
6.2.3
MGL errors (ID 4000-5000)
As from the moment data is sent to the Kona which is not correct, an error and sub error number will be displayed. Please find below a list with
explanations of these sub numbers.
Reinstalling the correct Mutoh Kona driver should solve this problem. Also be sure that the setting protocol is set to MGL.
138
Error screen
Sub number
Description
0
No parameters allowed
1
No parameter case is illegal
2
Not enough parameters
3
Too many parameters
4
Illegal command termination
5
Illegal command definition
6
Undefined program flow
7
Parameter size overflow
8
Error in HPGL command definition
9
Label out of limit error
other
Unknown HPGL error
AP-74380 - Revision 1.1