Service manual Kona cutting plotter
Part replacement
Adjustments necessary
After replacing/removing this part, it is necessary to make the following adjustment.
N°
1
2
Reassembling notes
Pay attention to the order of the installation of the leaf spring, washer and screw.
Step 1:
Step 2:
Step 3:
46
Description
EPOS calibration
YZ profile
Install the leaf spring.
Install the washer.
Tighten the screw.
EPOS calibration on page 103
YZ measurement on page 93
Link
AP-74380 - Revision 1.1