Sheeting-Off Knife Position - MUTOH Kona 760 Service Manual

Be sure to fasten the nuts to each other and verify the pressure once more.
Step 8:
4.1.5

Sheeting-off knife position

After replacing the following parts:
Pressure roller assembly replacement
Penhead assembly replacement
Sheeting-off mechanism
Adjustment procedure
Follow the procedure below to adjust the position of the sheeting-off knife.
Loosen the 2 screws fixing the sheet-off mechanism. Be sure that there is still some
Step 1:
friction between penhead and sheet-off bracket.
Remove the penhead cover.
Step 2:
Refer to
AP-74380 - Revision 1.1
Part
Pressure roller assembly on page 61
Penhead assembly on page 44
Sheet-off mechanism on page 49
Cover removal > Penhead cover on page 30
Service manual Kona cutting plotter
Adjustments and calibrations
Link
4
91