Service manual Kona cutting plotter
Parts replacement summary
The Service manual contains all necessary replacement procedures for every spare part
available for the Kona. Though, when replacing parts it might be possible that there are
additional actions necessary.
Please find below an overview:
1.
Pen head replacement
Perform Y-Z measurement (diagnostics)
Adjust sheeting-off knife position
Perform EPOS calibration
2.
Mainboard replacement
Before mainboard replacement
Take back-up parameters using the Mutoh CUTserver
After mainboard replacement
Uninstall and reinstall USB drivers on PC
Load firmware via USB.
Restore back-up parameters using the Mutoh CUTserver
If there are no back-up parameters available, you have to do the
following:
3.
Y-motor or Y speed reduction belt replacement
Adjust speed reduction belt to 3.5 kg
4.
X-motor replacement
Adjust belt tension to 3.5 kg
5.
Pressure roller assembly replacement
Adjust pressure of pressure rollers to 5,5 kg
4
Calibrate X and Y distance accuracy using the Mutoh CUTserver
Perform Y-Z measurement (diagnostics)
Perform EPOS calibration
page 44
page 93
page 91
page 103
page 67
page 98
page 96
page 94
page 99
page 102
page 93
page 103
page 35
page 87
page 33
page 86
page 61
page 90
AP-74380 - Revision 1.0