Advertisement
Quick Links
Upgrading the CP23xx-
RGBe/C laser software
This document provides upgrade instructions for projectors when the laser subsystem firmware (P/N:
001-115008-XX) is older than version 2.9.
This document does not apply for projectors produced later than May 2022. Refer to the upgrade
procedure in the projector model's Service guide.
Affected products
The following products are affected:
•
CP23xx-RGBe
•
CP23xx-RGB/C
Required components
The following components are required.
Required components
•
Windows laptop computer
•
Laser subsystem firmware (P/N: 001-115008-XX)
•
Light Source Software Upgrade kit (P/N: 003-007102-XX), which contains the following
components:
•
T interface convert USB interface (A)
•
ST-LINK/V2 debugger—SWD interface (B)
•
20 pin 2.54 flat cable convert XH2.54-3P terminal (C)
•
SD card
Upgrading the CP23xx-RGBe/C Firmware Instruction Sheet
020-103665-01 Rev. 1 (014-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
1
Advertisement
Related Manuals for Christie CP23 RGBe Series
Summary of Contents for Christie CP23 RGBe Series
- Page 1 T interface convert USB interface (A) • ST-LINK/V2 debugger—SWD interface (B) • 20 pin 2.54 flat cable convert XH2.54-3P terminal (C) • SD card Upgrading the CP23xx-RGBe/C Firmware Instruction Sheet 020-103665-01 Rev. 1 (014-2022) Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
- Page 2 The current version of the laser subsystem firmware (available in the Laser Diagnostic menu). If it is version 2.9 or newer, use the standard Christie upgrade procedure instead of the procedure outlined in this document. Updating the laser driver board Follow these steps to install the ST-LINK Utility firmware.
- Page 3 5. Power on the projector to Standby mode. 6. Copy the JM binary file to a location on the laptop. Upgrading the CP23xx-RGBe/C Firmware Instruction Sheet 020-103665-01 Rev. 1 (014-2022) Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
- Page 4 Follow these steps to upgrade the laser touch panel user interface from the SD card. 1. Remove the four screws securing the top cover of the laser touch panel and remove it. Upgrading the CP23xx-RGBe/C Firmware Instruction Sheet 020-103665-01 Rev. 1 (014-2022) Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
- Page 5 3. Christie recommends upgrading only what needs to be upgraded. The projector automatically reboots when the upgrade completes. 4. Log into the Christie touch panel user interface to repeat the upgrade. During this upgrade, the projector updates the laser driver board firmware. During the...
-
Page 6: Technical Support
Upgrading the CP23xx-RGBe/C laser software Technical support Technical support for Christie Cinema products is available at: • Support.cinema@christiedigital.com • +1-877-334-4267 • Christie Professional Services: +1-800-550-3061 or NOC@christiedigital.com Upgrading the CP23xx-RGBe/C Firmware Instruction Sheet 020-103665-01 Rev. 1 (014-2022) Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.