Xerox WorkCentre 5790 Series Service Manual page 9

• 173384 Bold, dark, smeared (blurred) characters, heat damage to drum
• 338812 XCRU noise, end of cycle grunt, moo, moan
• 640783 Re-occuring reorder fuser, scanner fualt, replace XCRU message
• 783324 Output tray 1 out of service, check for obstruction
• 1055407 Dead machine or blank UI at install
• 1139346 08-150 Jams with noise
• 1154339 Ozone Deletions and Seal Repair Kit
• 1172776 09-060 HVPS faults caused by a shorted dev bias harness
• 1183941 Erratic operation, shuts down 4 to 6 seconds after power on
• 1195182 Please check output bin for blank of particially images sheets
• 1223654 RX for 113R672
• T7748-07-01 Ozone Deletion and Seal Repair Kit
• T7764-08-08 Boot up failure after replacing IOT PWB or software module
• T7769-08-22 Decurler Inverter Unit for OCT Configurations
• T7903-03-30 SIP Diagnostic
• T7908-04-02 Toner Contamination
• T312692 09-341 Scorotron cleaning failed
Bus Update May 2013
The following procedures are updated:
• Change History
• SCP 4 Fault Analysis
• SCP 5 Subsystem Maintenance
• SCP 6 Final Actions
• RAP 01-300 Front Door Open
• RAP 03-360, 03-408 to 03-410, 03-418 IOT to Output Device Error
• RAP 03-412 Foreign Device PWB Fault
• RAP 03B Mark Service Unavailable
• RAP 04A main Drive Motor and Photoreceptor Motor
• RAP 07-353 Tray 1 Elevator Lift Failure
• RAP 07-354 Tray 2 Elevator Lift Failure
• RAP 07-373 Tray 5 Elevator Lift Failure
• RAP 07A Tray 1and Tray 2 Empty
• RAP 07D Bypass Tray
• RAP 07H Tray Out of Service
• RAP 07J Tray 5 Empty
• RAP 08-101 Tray 1 Misfeed
• RAP 08-103B, 08-113B Tray 3 Misfeed RAP (W/TAG 151)
• RAP 08-104B, 08-114B Tray 4 Misfeed RAP (W/TAG 151)
• RAP 08-106 Lead Edge Late to Tray 1 Feed Sensor
• RAP 08-108B Tray 3 or Tray 4 Paper Feed Jam (W/TAG 151)
• RAP 08-115A, 08-117A Tray 5 Misfeed (35-55 ppm)
• RAP 08-115B, 08-117B Tray 5 Misfeed (65-90 ppm)
• RAP 08-132 Tray 3 Paper Feed Jam (W/TAG 151)
Xerox® WorkCentre® 5790 Family
• RAP 08-150A, 151A Registration Jam (35-55 ppm)
• RAP 08-150B, 151B Registration Jam (65-90 ppm)
• RAP 08-190 Post Jam Clearance Initialization
• RAP 09-060 HVPS Fault
• RAP 09-310, 09-390 Low Toner Sensor Failure
• RAP 09-341, 09-342 Scorotron Cleaning Failure
• RAP 09-360, 09-361, 09-362, 09-363 Toner Concentration Sensor Failure
• RAP 09-399 Incompatible Xerographic Module
• RAP 09B Waste Toner Full Sensor
• RAP 10-135, 10-136, 10-137, 10-138 Trail Edge Late from Inverter Sensor
• RAP 11-007-110, 11-008-110, 11-312-110, 11-313-110, 11-319-110 Rear Tamper Move
Failure
• RAP 10-315, 10-320, 10-321, 10-323, 10-340, 10-350, 10-360, 10-365, 10-380 Fuser
Over Temperature
• RAP 11-130-110, 11-132-110 Paper Exiting to Bin 0
• RAP 11-140-120, 11-142-120 Sheet Late to Bin 1
• RAP 11-300-120, 11-302-120, 11-303-120 Interlocks
• RAP 11-320-120, 11-322-120 Ejector Movement Failure
• RAP 11C-120 1K LCSS Power Distribution
• RAP 11-061-171, 11-416-171 HVF BM Creasing
• RAP 11-188-171, 11-189-171 HVF Nip Split
• RAP 11-140-171, 11-142-171 HVF 2nd to Top Exit Sensor
• RAP 11-300-171, 11-302-171, 11-303-171 HVF Docking and Interlock
• RAP 11-306-171, 11-309-171 HVF Inserter Interlock
• RAP 11-307-171, 11-308-171, 11-303-171 Tri-folder Interlock
• RAP 11-371 to 11-377-171 HVF Stapler Position and Priming
• RAP 11-479-171 Inserter paper Length Fault
• RAP 11A-171 HVF power Distribution
• RAP 11D-171 Booklet Quality
• RAP 11M-171 Curl Suppressor
• RAP 14-110B Scan Carriage Home Sensor (W/TAG 150)
• RAP 19-401, 19-402, 19-403 Out of Memory Resources
• RAP OF1 Audible Noise
• RAP OF3 Dead Machine
• RAP OF4A Status Codes in Numerical Order
• RAP OF4B Status Messages in Alphabetical Order
• RAP OF5 Boot Up Failure
• RAP IQ1 Image Quality Entry
• REP 7.14 Tray 5 Stack Height Sensor
• REP 7.27 HCF Control PWB (W/TAG 151)
• REP 8.5 Registration Clutch
• REP 8.24 Tray 1 or Tray 2 Feed Sensor
• REP 11.1-171 HVF Covers
May 2013
vii
Introduction
Change History