01D +3.3V Distribution RAP
Use this RAP to identify +3.3V distribution problems.
NOTE: Short circuit or overload of +3.3V or +5V supply will result in all outputs off, except
+3.3VSB (standby).
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP
14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Refer to
Figure 1
and
Figure
2. Go to the appropriate component in the list that follows that has
a suspect +3.3V supply. Check the wiring,
•
ROS,
PL 6.10 Item
4.
–
Flag
1, P/J18,
PJ120.
•
Paper path module components, waste toner door switch,
interlock,
PL 7.30 Item
3.
–
Flag
8, P/J7.
–
Flag
5, P/J27.
•
Bypass tray width sensor and bypass empty sensor,
–
Flag
6, P/J10.
–
Flag
5, P/J27.
•
Paper path module components (35-55 ppm); IOT exit sensor,
sensor,
PL 8.22 Item
4, wait sensor,
Paper path module components (65-90 ppm); IOT exit sensor,
sensor,
PL 8.20 Item
4, wait sensor,
–
Flag
7, P/J5.
–
Flag
5, P/J27.
•
Power distribution PWB,
PL 3.24 Item
–
Flag
9,
P/J25
•
Single board controller PWB,
PL 3.24 Item
–
Flag
10, P/J137, P/J106.
–
Flag
9, P/J25, P/J131.
•
DADH PWB,
PL 5.10 Item
5.
–
Flag
11, P/J132,
PJ152,
P/J188.
–
Flag
9, P/J25, P/J131.
•
UI control PWB,
PL 2.10 Item
11.
–
Flag
12, P/J133,
P/J130
•
Scanner PWB,
W/TAG
150.
PL 14.15 Item
–
Flag
13, P/J135, P/J920.
–
Flag
13, P/J136, P/J920.
–
Flag
9, P/J25, P/J131.
•
CCD PWB, W/O
TAG
150.
PL 14.25 Item
–
Flag
13, P/J135, P/J450.
–
Flag
9, P/J25, P/J131.
Xerox® WorkCentre® 5790 Family
WARNING
GP
7.
PL 9.10 Item
6, left hand door
PL
7.30.
PL 10.11 Item
PL 8.15 Item
3, registration sensor,
PL 8.15 Item
PL 10.11 Item
PL 8.15 Item
3, registration sensor,
PL 8.17 Item
5.
3.
4.
19.
•
Riser PWB,
PL 3.22 Item
–
Flag
14, P/J138, P/J155, P/J157.
–
Flag
9, P/J25, P/J131.
•
Embedded fax PWB,
–
Flag
14, P/J138, P/J157, P/J155.
–
Flag
9, P/J25, P/J131.
13, duplex
3.
13, duplex
3.
May 2013
2-35
3.
PL 20.10 Item
4.
Status Indicator RAPs
01D