Table of Contents
Advertisement
1.
Open the tray. Rotate the shafts. Close the tray and repeat the measurements.
2.
To improve continuity, remove the tray 3 takeaway roll,
clean the conductive plastic bearings and shaft. Then install the removed components.
Clean inside and outside of the
conductive plastic bearings
Conductive
plastic
bearing
Figure 17 Component cleaning
3.
If necessary remove the tray 3 and 4 transport roll and bearings,
ure
18, clean the bearings and shaft. Then install the removed components.
Clean inside and outside
of the bearings
Bearing
Figure 18 Component cleaning
Xerox® WorkCentre® 5790 Family
4.
REP
8.46. Refer to
Figure
17,
Conductive
plastic
bearing
Clean the bearing areas of
the tray 3 takeaway roll shaft
Tray 3 paper tray guide
REP
8.47. Refer to
Fig-
Bearing
Clean the bearing areas of
the tray 3 and 4 transport roll
May 2013
2-17
Empty tray 3 of paper. Refer to
Figure
19, disconnect and clean the tray 3 ground harness
connectors. Then install the removed components.
Tray 3 lift plate
Figure 19 Tray 3 grounding
Connectors
Tray 3 ground harness
Status Indicator RAPs
01A
Advertisement
Chapters
Table of Contents
