Xerox WorkCentre 5790 Series Service Manual page 181

07-302 Tray 2 Open During Run RAP
07-302 Tray 2 was opened during run when the paper is fed from tray 2.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Ensure that the tray is pushed fully home,
• Check for obstructions behind the tray.
Procedure
Enter dC330 code 07-302 tray 2 home switch, S07-302. Press Start. Open and fully close the
tray. The display changes.
Y N
Go to Flag 1. Check S07-302. Refer to:
• GP 13 How to Check a Switch.
• Tray 1 home (H) +5V. Check at the switch terminal on the PWB,
• 01E +5V Distribution RAP.
• 01B 0V Distribution RAP.
Install new components as necessary:
• Tray 1 and 2 control PWB, PL 7.10 Item
Perform the following:
• Check the paper size leaf spring is mounted correctly,
If TAG 101 has not been struck then install a paper feed module frame repair kit,
Item 4.
• Check the actuator on the paper tray,
• If the problem continues, install new Tray 1 and 2 control PWB,
Xerox® WorkCentre® 5790 Family
WARNING
Figure 1.
Figure
2.
PL 7.10 Item 3.
Figure 1.
PL 7.10 Item
2.
PL 31.14
2.
May 2013
2-149
Tray 2 home switch
Tray home
(top switch) S07-302
actuator cam
Figure 1 Component location
Tray 1 and 2
control PWB
Status Indicator RAPs
07-302