Xerox WorkCentre 5790 Series Service Manual page 221

Figure 2 Circuit diagram
Xerox® WorkCentre® 5790 Family
07H Tray Out of Service RAP
The IOT has detected a fault in the tray and determines that the tray is out of service. The fol-
lowing status codes and messages will be displayed.
07-541 Tray 1 out of service.
07-542 Tray 2 out of service.
07-543 Tray 3 out of service.
07-544 Tray 4 out of service.
07-546 Tray 5 out of service.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
• Switch off the machine, then switch on the machine,
• Check that the tray elevator cables and mechanisms are located correctly.
• Check that the tray is pushed fully home.
• Check for obstructions behind the tray.
• Check the feed heads.
Procedure
If tray 1 or tray 2 are out of service. Check the following and install new components as neces-
sary:
• Paper tray 1 and 2 assembly,
• Paper tray 2 assembly, PL 7.10 Item
• Tray 1 and 2 paper feed assembly,
If tray 3 or tray 4 are out of service, go to one of the following RAPs:
• 07F Tray 3 or Tray 4 Out of Paper RAP (W/O
• 07G Tray 3 or Tray 4 Out of Paper RAP
If tray 5 is out of service, go to 07J
May 2013
2-189
WARNING
14. Disconnect the power cord. Electricity can cause
GP 14.
PL 7.10 Item 26.
27.
PL 8.26 Item 1, PL 8.26 Item 2.
TAG 151).
(W/TAG 151).
Tray 5 Empty RAP.
Status Indicator RAPs
07G, 07H