Starting The Engine; Cold Engine Starting Procedure - Honda CL360 Owner's Manual

Table of Contents

ST ART I NG TH E ENG I N E '///////////////////////////////////////////////////////////////////////////////////////////////////////////

Cold Engine Starting Procedure

1. Turn the fuel valve to the "ON"

position (page 17).

2. Insert the key into the main switch

and turn to the "ON" position. At this

time, observe the green neutral indica-

tor light (page 11 ). The light will be

lighted when the transmission is in the

neutral position.

3. Make sure that the engine stop switch

(page 13) is in the "RUN" position.

4. Raise the choke lever to the fully

closed position@

5. Open the throttle slightly and press

the starter button. If the engine does

not start within 5 seconds, release the

starter button and allow the starting

motor to rest for approximately 10

seconds before again pressing the

starter button. If the engine does not

Choke lever

start readily with the starting motor

use the kick starter pedal to start the

engine.

If the engine fails to start after several

repeated

attempts,

it may have be-

come flooded with excess fuel. To

clear the

engine,

turn off the main

Table of Contents