Edge-Core ECS4660-28F Management Manual page 221

A port can only be assigned to one traffic-segmentation session.
◆
A downlink port can only communicate with an uplink port in the same
◆
session. Therefore, if an uplink port is not configured for a session, the
assigned downlink ports will not be able to communicate with any other
ports.
If a downlink port is not configured for the session, the assigned uplink
◆
ports will operate as normal ports.
P
ARAMETERS
These parameters are displayed:
Session ID – Traffic segmentation session. (Range: 1-4)
◆
Direction – Adds an interface to the segmented group by setting the
◆
direction to uplink or downlink. (Default: Uplink)
Interface – Displays a list of ports or trunks.
◆
Port – Port Identifier. (Range: 1-28)
◆
Trunk – Trunk Identifier. (Range: 1-8)
◆
W I
EB NTERFACE
To configure the members of the traffic segmentation group:
Click Interface, Traffic Segmentation.
1.
Select Configure Session from the Step list.
2.
Select Add from the Action list.
3.
Enter the session ID, set the direction to uplink or downlink, and select
4.
the interface to add.
Click Apply.
5.
Figure 65: Configuring Members for Traffic Segmentation
– 221 –
| Interface Configuration
C 5
HAPTER
Traffic Segmentation