How To Set Battery And The Time Setting - Omron RX2 Series User Manual

3 Operation
Precautions for Correct Use
• To display time in retry history and trip history, you need to configure clock settings.
• To use the clock function, you need an optional battery that is separately sold (CR2032, 3V).
• When the clock function is not used with being retained, the display of error history and trip
history are shown below.
STOP
Retry history
Total count
1. r007 --/--/--
2. r001 --/--/--
3. r001 --/--/--
4. r009 --/--/--
5. r012 --/--/--
3-1-5

How to Set Battery and the Time Setting

The clock function of LCD operator can display the date and the time of trip/retry history.
To use this function, prepare an optional battery (CR2032, 3V) for the LCD operator.
The procedure to set the clock function and insert a battery is as follows:
1
Show a system setting screen of LCD operator.
Select "10: battery level warning."
Then select "01: valid."
2
Power-off the inverter.
Make sure that the power light of LCD operator is off.
3
Remove the LCD operator from the inverter.
4
Open the lid on the back side of LCD operator and insert a battery.
Make sure the positive side of the battery can be seen.
5
Close the lid and set the LCD operator to the inverter.
6
Power-on the inverter.
7
Make sure that the following screen comes up. Set the date and time.
- 60.00]
STOP
Battery of keypad run - down.
Set the time again.
2000/01/01 00:00
Menu
3 - 12
H06
M1
20 times
--:--
--:--
--:--
--:--
--:--
CTRL M1 UTL
NRDY
SIM Ez_S TRQ
Optional
oFW 0.00Hz
STOP
Trip history
Total count 20 times
1. E007 --/--/--
2. E001 --/--/--
3. E001 --/--/--
4. E009 --/--/--
5. E012 --/--/--
H03
STO
Hz
device
High-function General-purpose Inverter RX2 Series User's Manual
H06
M1
--:--
--:--
--:--
--:--
--:--