Omron RX2 Series User Manual page 513

(c) Once the desired position is reached, press the save (2 key) on the LCD operator.
(d) The current position is set in the are corresponding to the position command destination set to the
[AE-60] teaching selection. (However, [AE-60] itself is not saved. After power-off or the reset, it
becomes 00 (X00).)
[AE-60] setting value
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
If the power supply of the inverter control circuit (R0,T0) is input, the teaching is allowed. Since operat-
ing the work with an external unit, etc. also enables the current position monitor to work, the teaching is
allowed even if the operation is performed without an inverter.
Precautions for Correct Use
However, make sure that the power supply of the inverter power circuit (R, S, T) is shut off. •Or
make sure that the connection between the output of the inverter (U, V, W) and the motor is
shut off. Otherwise, you run the risk of injury and damage.
High-function General-purpose Inverter RX2 Series User's Manual
Position command to be set
[AE-20]: Multistage position command 0
[AE-22]: Multistage position command 1
[AE-24]: Multistage position command 2
[AE-26]: Multistage position command 3
[AE-28]: Multistage position command 4
[AE-30]: Multistage position command 5
[AE-32]: Multistage position command 6
[AE-34]: Multistage position command 7
[AE-36]: Multistage position command 8
[AE-38]: Multistage position command 9
[AE-40]: Multistage position command 10
[AE-42]: Multistage position command 11
[AE-44]: Multistage position command 12
[AE-46]: Multistage position command 13
[AE-48]: Multistage position command 14
[AE-50]: Multistage position command 15
8 Applied Settings
8 - 113
8