X265; Time Code Burn-In Filter - Telestream Lightspeed Live Capture User Manual

272 Appendix B: Containers, Codecs, and Vantage Actions
QuickTime Output
Command Line (option)
Configure the compressor using x264 command line syntax. For setting specific x264
parameters, you can enter x264 CLI commands (separated by spaces) to execute them.
For best results, be sure to use long form: --bframe 5, for example. Use of short form (-b
5) is not recommended.
The following x264 command line parameters are not supported:
--fake-interlaced
--nal-hrd cbr
--profile
--video-format
--bitrate

x265

Profile
- Main
- Main 10
- Main 10 Intra
Bit Rate (in kbps)
- Between 512 and 50,000
Command Line (option)
Configure the compressor using x265 command line syntax. For setting specific x265
parameters, you can enter x265 CLI commands (separated by spaces) to execute them.
For best results, be sure to use long form: --bframe 5, for example. Use of short form (-b
5) is not recommended.
The following x265 command line parameters are not supported:
--fake-interlaced
--nal-hrd cbr
--profile
--video-format
--bitrate

Time Code Burn-in Filter

Select to have the media timecode burned into the output video.
- X Position: Burn timecode in at 0-4096 pixels from upper left corner.
Lightspeed Live Capture User Guide