Creating A Capture Action Workflow - Telestream Lightspeed Live Capture User Manual

118 Creating Capture & Tape Action Workflows
Creating and Activating the Capture Action Workflow

Creating a Capture Action Workflow

Follow these steps to create and activate a Capture action workflow:
1. Launch the Vantage Workflow Designer by double-clicking the desktop
2. Select File > Create New Workflow and name the workflow. You may also
Note: To avoid workflow failures, do not use these characters in workflow names:
3. In the Workflow Design panel, select Live from the top tool bar and drag a Capture action
Note: If multiple Capture Actions are used in a single workflow and each action is
actively recording, the Capture UI Status panel workflow thumbnail card and Status
page will display inaccurate record state information. For best practices, use only one
Capture Action per workflow.
4. Select the Inspector (circled i) icon on the upper left corner of the action to open
icon.
need to create a Category (File > Create New Category), which is a folder
where the workflow will be stored. The default workflow naming
pattern is [Workflow Name]_[Source Name].
` * | \ : ; " ' < > ? /
into the workspace below.
the Inspector and configure the action, or double-click the action to open the
Inspector.
Lightspeed Live Capture User Guide