Suzuki SY413 Service Manual page 1404

0B-8 MAINTENANCE AND LUBRICATION
1.3L, 1.6L Engine
Engine oil capacity
Oil pan capacity
Oil filter capacity
Others
Total
4) Apply engine oil to new oil filter O-ring.
5) Screw new filter on oil filter stand by hand until filter O-ring con-
tacts mounting surface.
6) Tighten filter 3/4 turn from the point of contact with mounting sur-
face using an oil filter wrench.
Special Tool
(A): 09915-47330
Tightening Torque (Reference)
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
7) Replenish oil until oil level is brought to FULL level mark on dip-
1.8L Engine
stick (oil pan and oil filter capacity). Filler inlet is at the top of cyl-
inder head cover.
8) Start engine and run it for three minutes. Stop it and wait another
5 minutes before checking oil level. Add oil, as necessary, to
bring oil level to FULL level mark on dipstick.
1.3L and 1.6L Engine model
about 3.1 liters
(6.5/5.5 US/lmp pt.)
about 0.2 liters
(0.4/0.3 US/lmp pt.)
about 0.3 liters
(0.6/0.5 US/lmp pt.)
about 3.6 liters
(7.5/6.3 US/lmp pt.)
NOTE:
Engine oil capacity is specified as above table.
However, note that amount of oil required when actually
changing oil may somewhat differ from data in above table
depending on various conditions (temperature, viscosity,
etc.).
9) Check oil filter and drain plug for oil leakage.
CAUTION:
To tighten oil filter properly, it is important to accurate-
ly identify the position at which filter O-ring first con-
tacts mounting surface.
1.8L Engine model
about 4.5 liters
(9.5/7.9 US/lmp pt.)
about 0.2 liters
(0.4/0.3 US/lmp pt.)
about 0.3 liters
(0.6/0.5 US/lmp pt.)
about 5.0 liters
(10.6/8.8 US/lmp pt.)