Chrysler PT Cruiser 2001 Service Manual Supplement page 1453

23 - 44 BODY
REMOVAL AND INSTALLATION (Continued)
FRONT DOOR GLASS
REMOVAL
(1) Remove door trim panel and water dam.
(2) Remove inner door belt weatherstrip (Fig. 36).
(3) Lower door glass to bottom of door to gain
access to attaching bolts.
(4) Loosen bolts attaching door glass to window
regulator lift plates.
(5) Disengage door glass from regulator.
(6) Lift door glass upward, tilting down at the
front and up at the back, out of the opening at the
top of door.
Fig. 36 Front Door Glass–Power Window
1 - FRONT DOOR WINDOW GLASS
2 - FRONT DOOR
3 - FRONT DOOR WINDOW POWER REGULATOR
4 - POWER WINDOW REGULATOR WIRING CONNECTOR
5 - FRONT DOOR SPEAKER
6 - SPEAKER WIRE CONNECTOR
INSTALLATION
(1) Carefully lower door glass through opening in
top of door.
(2) Position door glass into window regulator lift
plates (Fig. 36).
(3) Install bolts door glass to lift plates and do not
tighten.
(4) Raise glass to the full up position and then
tighten the lift plate bolts.
(5) Install inner door belt weatherstrip.
(6) Install door trim panel and water dam.
FRONT DOOR WINDOW REGULATOR
REMOVAL
(1) Remove front door trim panel.
(2) Remove front door glass from regulator chan-
nel.
(3) Loosen screws attaching window regulator
channel and crank housing to door panel (Fig. 36).
(4) Disengage screw and bolt heads from keyhole
slots in door panel.
(5) Loosen bolts attaching window regulator to
door panel.
(6) Disengage regulator from door panel, and
crank housing.
(7) Slide regulator rearward and rotate forward
end of roller channel through access hole in door
panel,
(8) Remove window regulator from door through
access hole in inner panel.
INSTALLATION
(1) Position window regulator and crank housing
on door panel through access hole in door panel (Fig.
36).
(2) Tighten bolts attaching window regulator to
door panel.
(3) Engage window regulator bolt heads on chan-
nel to key hole slots in door panel.
(4) Tighten screw attaching window regulator
channel and crank housing.
(5) Position glass to regulator roller channel.
(6) Tighten fasteners attaching door glass to roller
channel.
(7) Install door trim panel.
FRONT DOOR CHECK STRAP
REMOVAL
(1) Remove door trim panel and water dam.
(2) Remove bolt attaching check strap to hinge pil-
lar.
(3) Remove door speaker.
(4) Remove glass run.
(5) Remove bolts attaching check strap to door end
frame.
(6) Remove check strap and cover from vehicle.
INSTALLATION
NOTE: Do not grease check strap.
(1) Assemble check strap cover to check strap.
(2) Position door check on vehicle and install bolts
attaching strap to door end frame.
(3) Install glass run.
(4) Install door speaker, if so equipped.
PT