Chrysler PT Cruiser 2001 Service Manual Supplement page 1272

PT
REMOVAL AND INSTALLATION (Continued)
Fig. 59 Interlock Cable at Steering Column-Typical
1 – IGNITION SWITCH
2 – CLIP
3 – INTERLOCK CABLE
4 – BTSI SOLENOID
Fig. 60 Ignition Key/Switch Positions
1 – ACC
2 – LOCK
3 – OFF
4 – ON/RUN
5 – START
INSTALLATION
CAUTION: When installing interlock cable assem-
bly, care must be taken not to bend exposed cable
wire and slug at shifter end of cable.
Fig. 61 Interlock Cable and Connector
1 – IGNITION LOCK CYLINDER
2 – INTERLOCK CABLE
(1) Route interlock cable through hole in instru-
ment panel below steering column and around to
gear shifter assembly.
(2) Turn the ignition key to the "OFF" or "ON/
RUN" position (Fig. 60).
(3) Install the interlock cable into the interlock
housing at the steering column (Fig. 62). Verify the
cable snaps into the housing and is fully seated.
Fig. 62 Interlock Cable at Interlock Housing
1 – IGNITION SWITCH
2 – INTERLOCK CABLE
(4) Return the ignition key to the "LOCK" position
(Fig. 60).
(5) Connect the BTSI solenoid connector (Fig. 59).
(6) Install steering
shrouds (Fig. 58).
(7) Install steering column lower cover (Fig. 57).
(8) Verify that shifter is in gated "PARK".
TRANSAXLE 21 - 87
column upper and lower