Chrysler PT Cruiser 2001 Service Manual Supplement page 1198

PT
REMOVAL AND INSTALLATION (Continued)
Fig. 34 Shift Cables at Transaxle
1 – CROSSOVER LEVER
2 – CROSSOVER CABLE
3 – SELECTOR CABLE
4 – SELECTOR LEVER
Fig. 35 Correct Orientation of Roll Pins
1 – OUTER ROLL PIN
2 – INNER ROLL PIN
Fig. 36 Axle Shaft Seal Removal
1 – AXLE SEAL
2 – PRY TOOL
INSTALLATION
(1) Clean axle shaft seal bore of any excess seal-
ant.
(2) Align axle shaft seal with axle shaft seal bore.
(3) Install axle seal on tool #6709 and C-4171 and
insert into axle shaft seal bore.
(4) Tap seal into position until seated against tran-
saxle case.
(5) Install axle shaft. Refer to DIFFERENTIAL
AND DRIVELINE for the correct procedures.
SHIFT SHAFT SEALS
It is not necessary to remove the shift shafts from
the transaxle to service the shift shaft seals.
REMOVAL
(1) Using a pick tool, pry up on the shift shaft seal
and remove seal from bore.
INSTALLATION
(1) Position new shift shaft seal in bore.
(2) Install shift shaft seal into bore using an
appropriate size deep–well socket.
TRANSAXLE 21 - 13