Chrysler PT Cruiser 2001 Service Manual Supplement page 1281

21 - 96 TRANSAXLE
REMOVAL AND INSTALLATION (Continued)
Fig. 91 O-ring Location
1 – INPUT SPEED SENSOR
2 – O-RING
INSTALLATION
(1) Verify o-ring is installed into position.
(2) Install and tighten input speed sensor to 27
N·m (20 ft. lbs.).
(3) Connect speed sensor connector.
(4) Install the battery tray (Fig. 89).
(5) Install the battery and hold down clamp (Fig.
88).
(6) Install air cleaner assembly (Fig. 87).
(7) Connect battery cables.
OUTPUT SPEED SENSOR
CAUTION: When disconnecting speed sensor con-
nector, be sure that the connector weather seal
does not fall off or remain in old sensor.
REMOVAL
(1) Disconnect the battery cables.
(2) Remove air cleaner assembly (Fig. 92).
(3) Remove the battery hold down clamp and
remove the battery (Fig. 93).
(4) Remove the battery tray (Fig. 94).
(5) Disconnect ouput speed sensor connector.
(6) Unscrew and remove output speed sensor (Fig.
95).
(7) Inspect speed sensor o-ring (Fig. 96) and
replace if necessary.
INSTALLATION
(1) Verify o-ring is installed into position (Fig. 96).
(2) Install and tighten output speed sensor to 27
N·m (20 ft. lbs.).
Fig. 92 Air Cleaner Assembly Removal/Installation
1 – AIR CLEANER ASSEMBLY
Fig. 93 Battery Removal/Installation
1 – BATTERY
(3) Connect speed sensor connector.
(4) Install the battery tray (Fig. 94).
(5) Install the battery and hold down clamp (Fig.
93).
(6) Install air cleaner assembly (Fig. 92).
PT