Chrysler PT Cruiser 2001 Service Manual Supplement page 1368

PT
DISASSEMBLY AND ASSEMBLY (Continued)
of the differential (Fig. 402). The turning torque
should be between 5-18 inch-pounds.
NOTE: If turning torque is too high install a .05mm
(.002 inch) thicker shim. If the turning torque is too
low, install a .05mm (.002 inch) thinner shim. Repeat
until 5-18 inch-pounds
obtained.
CLEANING AND INSPECTION
CLEANING VALVE BODY
Prior to removing any transaxle parts, plug all
openings and clean unit, preferably by steam. Clean-
liness through entire disassembly and assembly can-
not be overemphasized. When disassembling, each
part should be washed in a suitable solvent, then
dried by compressed air. Do not wipe parts with
shop towels. All mating surfaces in the transaxles
are accurately machined; therefore, careful handling
of all parts must be exercised to avoid nicks or burrs.
NOTE: Tag all springs, as they are removed, for
reassembly identification.
ADJUSTMENTS
GEARSHIFT CABLE
The engine starter should only operate when the
transaxle shift lever is in the PARK (P) or NEUTRAL
(N) positions. If the engine starts in any other gear
position, or the vehicle rolls when the shifter is in
gated PARK (P), a gearshift cable adjustment is nec-
essary.
ADJUSTMENT
(1) Loosen set screw and remove knob from shifter
handle (Fig. 403).
(2) Remove the center console assembly as shown
in (Fig. 404).
of turning torque is
Fig. 403 Gearshift Knob Removal/Installation
1 – SHIFTER KNOB
2 – SET SCREW
Fig. 404 Center Console Removal/Installation
1 – CENTER CONSOLE
TRANSAXLE 21 - 183