Chrysler PT Cruiser 2001 Service Manual Supplement page 1428

Table of Contents

Advertisement

PT
REMOVAL AND INSTALLATION (Continued)
1 – SUNROOF MODULE
2 – SUNROOF FRONT DRAIN HOSE
3 – CLIPS
(3) Connect express module, drive motor, and con-
trol switch wire connectors.
(4) Test sunroof operation, adjust as necessary.
(5) Finish installing headliner. Refer to Headlining
Removal and Installation for proper procedures.
(6) Install sunroof opening trim lace. Refer to Sun-
roof Opening Trim Lace.
(7) Connect the control switch wire connector.
Install control switch.
REAR HOUSING HOSE
REMOVAL
(1) Move glass panel to the fully closed position.
(2) Remove sunroof opening trim lace.
(3) Disconnect the control switch and wire connec-
tor.
(4) Remove headliner.
(5) Disconnect the drain hose from the sunroof
housing (Fig. 3).
(6) Drain any liquid from hose connection, if nec-
essary.
(7) Attach new drain hose to old hose with tape
that is to be replaced.
(8) Work the old hose back and forth to loosen the
sealer.
(9) Pull the old hose out through the bottom and
the new hose through.
INSTALLATION
(1) Connect the drain hose to the sunroof housing
and test drainage (Fig. 3).
Fig. 2 Front Drain Hose
(2) Set headliner into position.
(3) Connect express module, drive motor, and con-
trol switch wire connectors.
(4) Test sunroof operation, adjust as necessary.
(5) Finish installing headliner. Refer to Headlining
Removal and Installation for proper procedures.
(6) Install sunroof opening trim lace. Refer to Sun-
roof Opening Trim Lace.
(7) Connect the control switch wire connector.
Install control switch.
SUNROOF CONTROL SWITCH
REMOVAL
(1) Using a flat blade tool, release switch from the
headliner.
(2) Disconnect the wire connector from the switch.
INSTALLATION
(1) Connect the wire connector to the control
switch.
(2) Install control switch into headliner.
(3) Test sunroof operation.
SUNROOF WIND DEFLECTOR
REMOVAL
(1) Open sunroof glass panel.
(2) Remove screws attaching wind deflector straps
to front crossmember.
(3) Remove wind deflector. Rotate wind deflector
into the vertical position, 90° to the roof.
BODY
23 - 19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents