Chrysler PT Cruiser 2001 Service Manual Supplement page 1446

PT
REMOVAL AND INSTALLATION (Continued)
(5) Remove screws attaching wheelhouse splash
shield to front fender.
(6) Remove splash shield from vehicle.
Fig. 26 Front Wheelhouse Splash Shield
1 – FRONT FENDER
2 – FRONT FENDER SPLASH SHIELD
INSTALLATION
(1) Place splash shield in position on vehicle (Fig.
26).
(2) Install screws attaching wheelhouse splash
shield to front fender.
(3) Install push in fasteners attaching splash
shield to frame rail rearward of suspension.
(4) Install push in fasteners attaching splash
shield to frame rail forward of suspension.
(5) Install front wheel.
(6) Lower vehicle.
FRONT SIDE RAIL ACCESS PULLEY SPLASH
SHIELD
REMOVAL
(1) Hoist and support vehicle on safety stands.
(2) Remove front wheel.
(3) Remove fasteners attaching lower fascia and
air dam. Pull fascia forward to access fastener
attaching front edge of the splash shield.
(4) Remove push-in fasteners attaching side rail
access pulley splash shield to frame rail forward of
suspension (Fig. 27).
(5) Remove side rail access pulley splash shield
from vehicle.
Fig. 27 Front Side Rail Access Pulley Splash Shield
1 – FRONT FENDER
2 – FRONT SIDE RAIL ACCESS PULLEY SPLASH SHIELD
INSTALLATION
(1) Place side rail access pulley splash shield in
position on vehicle (Fig. 27).
(2) Install fasteners attaching side rail access pul-
ley splash shield to frame rail.
(3) Install fasteners attaching fascia and air dam.
(4) Install front wheel.
(5) Lower vehicle.
BODY 23 - 37