Chrysler PT Cruiser 2001 Service Manual Supplement page 1233

21 - 48 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
SHIFT SELECTOR SHAFT
REMOVAL
(1) Disassemble transaxle using the procedure out-
lined in this group.
(2) With the transaxle disassembled, remove the
selector shaft by pushing on the shaft from the out-
side. Pull shaft out from the inside.
INSTALLATION
(1) Reverse removal procedure to install selector
shaft.
SHIFT CROSSOVER SHAFT
REMOVAL
(1) Disassemble transaxle using the procedure out-
lined in this group.
(2) With the transaxle disassembled, remove the
crossover shaft seal.
(3) Using snap–ring pliers, remove the snap ring
at the crossover shaft bore (Fig. 160).
Fig. 160 Crossover Shaft Snap Ring
1 – SELECTOR SHAFT
2 – CROSSOVER SHAFT
3 – SNAP RING
(4) Push the crossover shaft in the case and
remove the crossover assembly.
INSTALLATION
(1) Reverse removal procedure to install crossover
shaft.
SHIFT SELECTOR SHAFT BUSHING
REMOVAL
(1) Remove selector shaft using procedure in this
group.
(2) Thread tool #6786 into bushing.
(3) Install slide hammer #3752 onto tool and
remove bushing using slide hammer (Fig. 161).
Fig. 161 Selector Shaft Bushing Removal
1 – SPECIAL TOOL 6786
2 – SHIFT SHAFT BUSHING
3 – SLIDE HAMMER C-3752
INSTALLATION
(1) Position replacement bushing over selector
shaft bore.
(2) Using an appropriate size deep–well socket,
install bushing in selector shaft bore (Fig. 162).
Fig. 162 Selector Shaft Bushing Installation
1 – DEEP WELL SOCKET
2 – SHIFTER SHAFT BUSHING
SHIFT CROSSOVER SHAFT BUSHING
REMOVAL
(1) Install slide hammer #3752 through the cross-
over bushing.
(2) Thread nut and washer onto slide hammer.
PT