Chrysler PT Cruiser 2001 Service Manual Supplement page 1100

PT
REMOVAL AND INSTALLATION (Continued)
FUEL LEVEL SENSOR
REMOVAL
(1) Remove fuel pump module. Refer to Fuel Pump
Module in this section.
(2) Depress retaining tab and remove the fuel
pump/level sensor connector from the BOTTOM of
the fuel pump module electrical connector (Fig. 20).
NOTE: The pump module harness on TOP of flange
is not serviceable or removable.
Fig. 20 Fuel Pump/Level Sensor Electrical
Connector
1 – ELECTRICAL CONNECTOR
(3) Remove the wedge lock from the electrical con-
nector (Fig. 21).
Fig. 21 Wedge Lock
(4) Using Special Tool C-4334 terminal remover or
equivalent, remove terminals from level sensor con-
nector (Fig. 22).
Fig. 22 Terminal Removal Tool-Tyipcal
1 – TERMINAL REMOVAL TOOL
2 – FUEL LEVEL SENSOR CONNECTOR
(5) Depress the tab and slide the sensor toward
the bottom of the fuel pump module (Fig. 23).
Fig. 23 Level Sensor Removal/Installation
1 – FUEL LEVER SENSOR
(6) Slide level sensor out of channel in module.
INSTALLATION
(1) Wrap wires into groove in back of level sensor
(Fig. 24).
(2) While feeding wires into guide grooves, slide
level sensor up into channel until it snaps into place
(Fig. 23). Ensure tab at bottom of sensor locks in
place.
FUEL SYSTEM 14 - 13