Chrysler PT Cruiser 2001 Service Manual Supplement page 1196

PT
REMOVAL AND INSTALLATION (Continued)
Fig. 29 Crossover Cable Adjustment Screw
1 – CROSSOVER ADJUSTMENT SCREW
Fig. 30 Crossover Lever Pin Procedure
1 – 1 ⁄ DRILL BIT
4
2 – SELECTOR CABLE
3 – CROSSOVER CABLE
(6) Position gearshift boot (Fig. 24) over the gear-
shift mechanism and engage tab on mount ring at
front to opening in console. Apply hand pressure to
engage bosses on mount ring of boot to console open-
ing slots.
(7) Position gearshift knob hole over the gearshift
mechanism (Fig. 23) and align the shift pattern.
(8) Strike knob with rubber mallet to engage knob
to mechanism.
(9) Verify that shift pattern is aligned properly.
VEHICLE SPEED SENSOR AND DRIVE PINION
REMOVAL
(1) Raise vehicle on hoist.
(2) Disconnect the speed sensor connector (Fig.
31).
CAUTION: Clean area around speed sensor before
removing to prevent dirt from entering the transaxle
during speed sensor removal.
(3) Remove speed sensor retaining bolt (Fig. 31).
Fig. 31 Speed Sensor and Pinion—Removal/
Installation
1 – CONNECTOR
2 – SENSOR
3 – O-RING
4 – SPEEDO PINION
(4) Remove speed sensor from transaxle.
CAUTION: Carefully remove vehicle speed sensor
so that sensor drive gear does not fall into tran-
saxle. Should sensor drive gear fall into the tran-
saxle during sensor removal, drive gear must be
reattached to sensor.
(5) Remove speed sensor drive gear from speed
sensor.
INSTALLATION
(1) Install pinion gear to speed sensor (Fig. 31).
(2) Using a NEW o-ring, install the speed sensor
to the transaxle (Fig. 31).
(3) Install the bolt and torque to 7 N·m (60 in.
lbs.).
(4) Connect speed sensor connector (Fig. 31).
(5) Lower vehicle and road test to verify proper
speedometer operation.
TRANSAXLE 21 - 11