Chrysler PT Cruiser 2001 Service Manual Supplement page 1337

21 - 152 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
(34) Apply 30 psi (206 kPa) air pressure to the
reverse clutch hose on Tool 8391. Measure and record
reverse clutch pack measurement in four (4) places,
90° apart.
(35) Take average of four measurements and com-
pare with reverse clutch pack clearance specification.
The reverse clutch pack clearance is 0.89-1.37
mm (0.035-0.054 in.). Select the proper reverse
clutch snap ring to achieve specifications:
REVERSE CLUTCH SNAP RING THICKNESS
4377195 1.53-1.58 mm (0.060-0.062 in.)
4412871 1.77-1.83 mm (0.070-0.072 in.)
4412872 2.02-2.07 mm (0.080-0.082 in.)
4412873 2.27-2.32 mm (0.090-0.091 in.)
(36) To complete the assembly, reverse clutch and
overdrive clutch must be removed.
(37) Install the #2 needle bearing (Fig. 301).
Fig. 301 Install No. 2 Needle Bearing
1 – #2 NEEDLE BEARING (NOTE 3 SMALL TABS)
2 – TABS UP
(38) Install the underdrive shaft assembly (Fig.
302).
Fig. 302 Install Underdrive Shaft Assembly
1 – UNDERDRIVE SHAFT ASSEMBLY
2 – #2 NEEDLE BEARING
(39) Install the #3 thrust washer to the underdrive
shaft assembly. Be sure five tabs are seated properly
(Fig. 303).
Fig. 303 Install No. 3 Thrust Washer
1 – #3 THRUST WASHER (NOTE 5 TABS)
2 – UNDERDRIVE SHAFT ASSEMBLY
PT