Chrysler PT Cruiser 2001 Service Manual Supplement page 1283

21 - 98 TRANSAXLE
REMOVAL AND INSTALLATION (Continued)
Fig. 98 TCM Removal/Installation
1 – LEFT RAIL
2 – BRACKET
3 – 60-WAY HARNESS CONNECTOR
4 – TRANSMISSION CONTROL MODULE (TCM)
INSTALLATION
(1) Install TCM to mounting bracket and tighten
four screws to 11 N·m (100 in. lbs.).
(2) Install TCM/bracket assembly and fasten with
three mounting screws (Fig. 98). Torque screws to 11
N·m (100 in. lbs.) torque.
CAUTION: TCM 60-way connector must be torqued
within 30-40 in. lbs. Improper torque may result in
connector damage.
(3) Connect the TCM 60-way connector and torque
to 4 N·m (35 in. lbs.).
(4) Install wheel house splash shield.
(5) Install left front wheel/tire assembly (Fig. 97).
Torque lug nuts to 135 N·m (100 ft. lbs.) torque.
(6) Lower vehicle.
(7) Connect the battery negative cable.
NOTE: If the TCM is being replaced with a NEW or
replacement unit, the Quick Learn AND Pinion Fac-
tor procedures must be performed. Refer to Service
Procedures for proper procedures.
VALVE BODY
REMOVAL
(1) Disconnect the battery cables.
(2) Remove air cleaner assembly (Fig. 99).
Fig. 99 Air Cleaner Assembly Removal/Installation
1 – AIR CLEANER ASSEMBLY
(3) Remove the battery hold down clamp and
remove the battery (Fig. 100).
Fig. 100 Battery Removal/Installation
1 – BATTERY
(4) Remove the battery tray (Fig. 101).
(5) Disconnect gearshift cable from manual valve
lever (Fig. 102).
PT