Chrysler PT Cruiser 2001 Service Manual Supplement page 1414

PT
REMOVAL AND INSTALLATION (Continued)
(15) Apply 150 mm (6 in.) lengths of 50 mm (2 in.)
masking tape spaced 250 mm (10 in.) apart to hold
molding in place until urethane cures.
(16) Install A-pillar moldings.
(17) Install cowl cover and wipers.
(18) Install inside rear view mirror.
(19) After urethane has cured, remove tape strips
and water test windshield to verify repair.
Fig. 2 Work Surface Set up and Molding Installation
1 – WINDSHIELD AND MOULDINGS
2 – URETHANE BEAD AROUND GLASS 7mm (.3 in.) FROM
EDGE
3 – BLOCKS
1 – WINDSHIELD GLASS
2 – WINDSHIELD ENCAPSULATION ROOF HOOKS
3 – WINDSHIELD ENCAPSULATION
4 – ADHESIVE HIGH VISCOSITY
QUARTER WINDOW GLASS
description of tools and adhesive systems that are
recommended for use in this procedure.
REMOVAL
(Fig. 5).
(Fig. 6).
WARNING: WEAR EYE AND HAND PROTECTION
WHEN HANDLING SAFETY GLASS. PERSONAL
INJURY CAN RESULT.
CAUTION: Do not damage body or trim finish when
cutting out glass or applying fence primer.
quarter window glass. Refer to Windshield Removal
for proper procedures.
vehicle.
Fig. 3 Lower Windshield Into Position
5 – ROOF OUTER PANEL
6 – WINDSHIELD OPENING UPPER FRAME
7 – CLEAN UP WITH VM & P NAPTHA/PRIMER BLACK OUT GLASS
PAINT
Refer to the Windshield Removal procedure for a
(1) Open liftgate
(2) Remove C & D Pillar upper trim panel (Fig. 4).
(3) Remove lower quarter trim panel as necessary
(4) Remove nuts attaching quarter window glass.
(5) Cut the sealer tape around the perimeter of the
(6) Remove the quarter window glass from the
BODY 23 - 5