Chrysler PT Cruiser 2001 Service Manual Supplement page 1872

*DOORS LOCKABLE WITH KEY IN IGN & DRIVER DOOR OPEN —
Continued
TEST
5 Open the driver door.
Note: Ensure that the Key is still in the Ignition Switch.
With the DRB, read the Key-In Ignition status.
Does the DRB show KEY-IN IGN: CLOSED ?
→ Go To 6
No
Yes → Go To 9
6 Disconnect the Ignition Switch connector.
Disconnect the Instrument Cluster connector.
Measure the resistance of the Key-In Ignition Switch Sense circuit between the
ignition switch connector and the instrument cluster connector.
Is the resistance below 5.0 ohms?
Yes → Go To 7
→ Repair the open Key-In Ignition Switch Sense wire.
No
7 Ensure the Instrument Cluster is connected before proceeding.
Disconnect the Ignition Switch connector.
Connect a jumper wire from the Key-In Ignition Switch Sense circuit in the ignition
switch connector to ground.
With the DRB, read the Key-In Ignition status.
Does the DRB show KEY-IN IGN: CLOSED ?
Yes → Replace the Ignition Switch.
→ Go To 8
No
8 If there are no possible causes remaining, view repair.
Repair
9 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Replace the Instrument Cluster (key-in ign open).
Perform BODY VERIFICATION TEST - VER 1.
Replace the Remote Keyless Entry Module.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOOR LOCKS/RKE
223
APPLICABILITY
All
All
All
All
All